I recently installed a Gen 2 Starlink, ethernet adapter and five ASUS ZenWiFi AX6600 Tri-Band Mesh WiFi 6 System (XT8)
The install went very well using one Asus router as the primary router with StarLink in bypass mode and the rest as nodes. It went so well that I ordered three more of the ASUS routers to install for a friend. Following the exact same procedure I bypassed the Starlink router and connected one Asus XT8 as the primary router. Everything seemed to go well except I have no access to the internet. I tried a total of three Asus XT8 as routers with no joy. I have reset both the Starlink and Asus routers more times that I can count. I have replaces cables, Ethernet adapters, everything except the Starlink Router. The only difference is the second Starlink router is about a month newer than the one that worked so well. I now have three days into this project trying every combination that I can think of. I can not think of anything else to try.
Any suggestions would be appreciate!
I had the same issue. Asus XT8 as router in bypass mode. The network using the Asus router worked fine but I could not get Internet through the bypassed Starlink modem router. It seemed to allow a trickle of data but nothing usable. Later I tried the Starlink as the router and used the Asus XT8 in WAP mode only. Worked fine as a WAP but …… when I tried to connect any wired device to my LAN the Starlink router would not allow them to access the Internet and kicked them off the network (it was a Sonos Arc soundbar and LG OLED TV). Very disappointed.