Dishypowa or McCown 800-GIGE-POE with REOLINK Power Adapter, 52V 2.88A.
Run 2 300ft Cat6 to the dishy location 1 for power 1 for data.
Power cable put 2 pair on negative 2 pair on Positive.
Cut your dishy cable in half and put a T568B on the dishy side.
Router side you will have to terminate T568B and put a rj45 coupler or just splice in and put a connector on the injector end.
Snip the end off the reolink power pack and splice in the 2 positive pairs to the center positive wire Should be white and the 2 negative pairs to negative bare outer wire.
Be sure to take your time and insolate each individual wire well with electrical tape as both the data and power splices will carry power to the injector.
Make a loop that includes the splice and tape it so that there isnt a risk of it getting jerked apart and causing a short.
Make sure your total data cable distance counting from router to dishy isnt over 330ft. If it has to be over 330ft you will have to work in a powered switch somewhere on the data cable.
Dishypowa or McCown 800-GIGE-POE with REOLINK Power Adapter, 52V 2.88A.
Run 2 300ft Cat6 to the dishy location 1 for power 1 for data.
Power cable put 2 pair on negative 2 pair on Positive.
Cut your dishy cable in half and put a T568B on the dishy side.
Router side you will have to terminate T568B and put a rj45 coupler or just splice in and put a connector on the injector end.
Snip the end off the reolink power pack and splice in the 2 positive pairs to the center positive wire Should be white and the 2 negative pairs to negative bare outer wire.
Be sure to take your time and insolate each individual wire well with electrical tape as both the data and power splices will carry power to the injector.
Make a loop that includes the splice and tape it so that there isnt a risk of it getting jerked apart and causing a short.
Make sure your total data cable distance counting from router to dishy isnt over 330ft. If it has to be over 330ft you will have to work in a powered switch somewhere on the data cable.